Pi4 w/ SSD.

Yeah maybe so. I’ll have a look at the entity names bit I think the loop.is being caused by something in my code. Will report back!

I have this set up to launch SmartTube instead of YouTube. Its working but there is a 1sec delay during which yhe YouTube screen flashes up. Also theres a looping issue if you use the back button to get out of SmartTube.

However, nice to have a way to remap the buttons without installing an additional app.

Nabu Casa is the way. Built by Home Assistant for Home Assistant, and utterly seamless and reliable (in my experience).

Most importantly it supports the developers who have created this amazing piece if software! Do it! 👍🏼🙏🏼

Thanks, I understood those names but I was curious about the Netflix and Jellyfin variables com.Netflix.ninja and org.Jellyfin.androidtv. How did you figure out what those were? I’ll need to do the same for YT and SmartTube.

Can you share a bit about how you got the names for the Netflix and Jellyfin variables please? My daughter asked me yesterday if we could change the YouTube button to SmartTube! I said I didn’t think it was possible! 👀

Thanks!

Solar mainly, and a few badges that double up as buttons. Weather and humidity bars utterly pointless but it took ages to get them right so I keep them.

I think this is the way too. I have never updated firmware on a device via the Pi. Always connected to a PC.

Can you confirm that you do not have ZHA and Z2M running at the same time?

• Disable ZHA
• Uninstall Z2M
• Reboot device
• Reinstall Z2M
• Try to run it again.

That’s what I would do next.